Characteristics of Drum pulley:

Monster-vulcanized natural rubber of high quality, the rubber hardness does not exceed 60 Shore degrees, wear-resisting, anti-corrosion performance is excellent, anti-aging performance is superior, under normal pressure temperature general service life reaches 5-10 years above, the adhesive strength between rubber and metal is excellent, the adhesive strength is (12-15N / MM) , and the domestic hot vulcanized roller rubber is (3-10N / MM) . The excellent adhesive strength effectively avoids the cracking and destocking of rubber layer and metal, the comprehensive performance-price ratio of rubber is excellent

Ceramic Pulley Lagging/ rubber coating property:

Drum packing is an important part and component of the belt conveying system. The rubber-coated roller can effectively improve the operation of the conveying system and protect the metal roller from wear. The rubber-covered surface of the diamond or herringbone pattern can increase the surface friction of the rubber plate. The utility model can effectively prevent the sliding friction between the roller and the belt, reduce the belt slipping, reduce the material adhesion on the surface of the roller, and thereby reduce the belt deviation and wear. Improve the efficiency of operation, so that the drum and belt synchronous operation, thus ensuring the operation of large-volume belt.

Drum pulley  installation at site matters:

1. The ambient temperature should be higher than 10 °C and the relative humidity should be lower than 90%
2. The binding surface should be dry and clean, free of grease, oil and chemicals
3. The above data are obtained from field experiments. Because of the different materials and working conditions, we suggest that you do the experiment in the field construction;
4. UNMIXED SC2002 and hardener should be sealed in good condition and stored in a cool, dry place;
5. Avoid contact with skin before curing. In case of accidental contact, should be quickly washed with water and soap.
6. When the material is applied, the force and uniformity should be paid attention to, and the material should be in full contact with the surface of the Matrix to achieve better bonding effect. Attention should be paid to the operating time limit of the product, which begins at the beginning of the mixing of the materials. In the environment of 25 degrees Celsius, should be used within 2 hours.
Kill. The adhesive SC2002 can be used immediately, and can be prepared for use after the bonding density is confirmed. It is suggested that after the drum is glued, the curing effect will be better after 24 hours