Pattern Conveyor Belt Installation Manual

Pattern conveyor belt is divided into many kinds, specifications and types are different, and their pattern also have a big difference, each pattern can be divided into three level. And the  pattern cleats height can be customized by  customers demand.

Belt width is  between 300-800 as usual, with core materials using ordinary cotton canvas conveyor belt. With the pattern conveyor belt is a good solution to the problem of frequent material decline. In the past when the use of flat conveyor belt will often cause the decline of materials, then

how to install the pattern conveyor belt ? 

1, For the first, it need to make a endless, we can do it for you or you may also find a belt joints company to do it.  It is depends on you.  Make a endless belt can be directly set in  the belt conveyor at site.  Installation and storage is more convenient.

2.  Put on the pattern belt rotating with the shaft core, and set the belt  on belt guide  , before set in frame ,  pls be attention about the top and bottom cover direction not reversed.

3. Belt guide roll pattern can not open shelves in the workplace, and at the folded belt has a sufficiently large radius of curvature, to prevent damage to the conveyor belt, fold prohibited heavy objects on the conveyor belt.

4. If you are replacing pattern conveyor belt. The new belt and the old belt could be connected together, conveyor belt unloading and installation of new automation devices simultaneously.

5. For horizontal operation of the conveyor, can be cut at any point in the old conveyor, inclined conveyor running direction, you need to choose the right point cut, to prevent falling out of control due to its own weight.

6. After the installation is complete, be sure to observe the test and see if there is deviation, etc., whether normal transport.
Meet the installation requirements are as follows:

Pattern Conveyor belt installation correct whether or not.  It is directly related to whether the belt conveyor can operate normally and the service life of the conveyor belt.

1. Drive device belt Conveyor drive device is composed of motor, reducer and drum. Installation requirements to maintain a certain level of horizontal, transmission drum brake in the middle of the raised shape, convex for the length of the drum 1/200, to prevent the conveyor belt running deviation.
2.  When the supporting means is supported by the roller and the roller carrier composition. Usually the roller spacing set to 1.5m to 1m, the spacing of idlers 2m to 3m, spacing is too greatly increased running resistance, accelerated wear, reduced belt life. To prevent the belt running, must every 5m to lOm, fitted with an automatic adjustment roller group.